Here's the details
20" 450 bushmaster upper on a Sharps mil spec lower with a Stag trigger assembly and a Stag 6 position stock, The stock as a Limb-saver recoil pad on it and the barrel has a custom brake installed, I will include the factory Izzy brake. The rifle has a Stag buffer with a Wolff heavy spring installed. It's got a Pmag 30mm scope ring and base assembly on it with shims down to 1" for the Bushnell 3x9 scope. The lower also has a aftermarket trigger guard installed (green). I use GI mags with this rifle but place a custom built single shot follower on top of the factory GI green anti-tilt follower for a single stack configuration. It comes with the following.
1) 5 round GI mag for the 450 cartridge
1) 10 round GI mag for the 450 cartridge
1) Dilren shingle shot follower (made by me)
90) rounds total of factory Hornady 250gr FTX loaded ammo
20) rounds total of hand loads in cut down .284 brass (225gr FTX)
20) rounds total of hand loads in Hornady brass (240gr XTP MAG)
20) rounds total of hand loads in Hornady brass (300gr XTP)
37) rounds total of hand loads in Hornady brass (250gr XTP)
21) pieces of empty Hornady brass
18) pieces of sized and primmed cut down once fired .284 brass
80) pieces of never fired cut down .284 brass
22) pieces of twice fired cut down .284 brass
1) 284 Win full length sizing die (used to size and de-cap the 450 and cut down .284 brass)
1) custom made Lee side crimp die
All you need is a 45acp bullet seating die a Lee #2 shell holder and a 5/8" spacer and your ready to load all the 450 ammo you want!
