450Bushmaster.net

Hey Guys,

I plan on ordering the PRI Gas Buster Charging handle. This will work on my .450 bush upper correct? I am assuming it does, but just want to make sure, sorry for the dumb question.

http://www.midwayusa.com/viewproduct/?p ... ber=856208

To answer your question, Yes, it will work since you are using a standard upper and bolt carrier. The only change is the bolt itself which doesn't affect the charging handle any.

Correct me if I am wrong, but the PRI was designed for high pressure loads or surpressed rifles that had alot of blowback. The .450 is hardly a high pressure load in fact it operates much lower than many common rifle rounds. I don't think you need the PRI, I think you would be better off getting a standard CH and adding at tactical latch or the BCM gunfighter CH and saving your $$ for ammo !

just my .02 anyway....

Thanks for the reply! All I really wanted was the latch anyways. I now have the PRI large latch on order with Midway!

Check out the BCM gunfighter charging handle. It is alot nicer in my opinion and cheaper to boot.