Moderator: MudBug
Gutpile wrote:Just got my Lee 450. 4 die set. So will I still need a modded crimp die? I wonder ?
Gutpile wrote:I guess using 250 FTX and near factory load duplications I will not need one. Is it truly required on the 225FTX or the Barnes?. I will be using starline brass
I was considering 250 grain non mag XTP to plink with
Gutpile wrote:I wonder, if one reduces the height of a shellholder. And
Makes the grooves in the collet slots wider would one accomplish the side Crimp with the Lee FCD in 450?
????? Then use crimp and seat die in separate operations so the mouth is .474. Then crimp below that?
It would fireform then using a Sharpe to index the cases on subsequent loads to the collet
Reinventing the wheel with out cutting the die
Return to Reloading for the 450b
Users browsing this forum: No registered users and 131 guests