Over crimped?

Talk about your 450b reloading experience, ask questions, etc...

Moderator: MudBug

Forum rules
Please try and keep it safe!

This information is the responsibility of the community, not the forum. 450bushmaster.net is not responsible if you blow yourselves up.

Re: Over crimped?

Postby Hoot » Thu Oct 18, 2018 12:45 pm

I'm surprised no one has mentioned this, considering I've said it plenty of times over the years but you need to seat the bullet so that the driving band groove is almost buried beneath the mouth with a little still peeking out, then drive the taper crimp down into the groove. Holds on quite well and without crimping down below about .474. I've even posted images and drawings about this. Also works on bullets with cannelures.

Hoot

Google is a great search engine when you point it specifically at this site as covered in this thread in the Hoot's Information Depository sub-forum.
In Theory, there is no difference between theory and practice. In Practice, there is.
User avatar
Hoot
 
Posts: 5083
Joined: Tue Feb 09, 2010 9:34 am
Location: Minnesota

Re: Over crimped?

Postby AR167 » Sun Oct 21, 2018 2:47 pm

Hoot wrote:I'm surprised no one has mentioned this, considering I've said it plenty of times over the years but you need to seat the bullet so that the driving band groove is almost buried beneath the mouth with a little still peeking out, then drive the taper crimp down into the groove. Holds on quite well and without crimping down below about .474. I've even posted images and drawings about this. Also works on bullets with cannelures.

Hoot

Google is a great search engine when you point it specifically at this site as covered in this thread in the Hoot's Information Depository sub-forum.


Thank you sir!

I got some new starline brass and loaded up some more. I think I finally got the taper crimp set right. All of the mouths on these were .475". They shot great in the Savage bolt action too! Looks like I'll be running about 36gr of Lil' Gun for this rifle lit by Rem 7 1/2's.
AR167
 
Posts: 21
Joined: Sun May 23, 2010 6:52 pm
Location: Baton Rouge, LA

Previous

Return to Reloading for the 450b

Who is online

Users browsing this forum: Google [Bot] and 19 guests