Cutting edge 250 grain Maximus bullets

[Cat Power]

That's a wicked looking hollow point. A little bigger than the 200 and 275 XPB's I shot awhile back. It would be interesting to see a "water shot" bullet to compare to the XPB's in This Thread.

Hoot

That is a cool thread. Thank you for posting

[Al in Mi]

200gr Barnes, real world deer recovery, 110yd ish frontal shot found in ham from my 45 Raptor, muzzle speed 2915 fps.

[Cat Power]

DCD5DA20-7C0F-4867-BE6B-541E56BEA559.jpeg (21.13 KiB) Viewed 6982 times

[Cat Power]

38D41BF0-E53A-4DD1-BFF2-5D716C8552E9.jpeg (19.87 KiB) Viewed 6982 times

4 shot group at 50 yards

I think these cutting edge bullets are gonna be good

[Al in Mi]

Nothing wrong there.

Are they designed to shear petals or mushroom?

[Cat Power]

Shear pedals

[coyote wacker]

I worked up some loads tonight

38 grains of lil gun at 2.311” col

Try them out Saturday

I been shooting CEB 160 gr.Raptor around 2800 fps and the 250 gr. Raptor 2400 fps they are both hammers....going to use the 250's hopefully on a bear....

Depending on how long your throat was cut you could load a little longer gaining some powder space = more velocity

Who made your Blaser barrel ?

[Cat Power]

J sip and sons in Utah

I had it made 22”

No taper, standard contour

Pretty sure there aren’t many made

[Cat Power]

I worked up some loads tonight

38 grains of lil gun at 2.311” col

Try them out Saturday

I been shooting CEB 160 gr.Raptor around 2800 fps and the 250 gr. Raptor 2400 fps they are both hammers....going to use the 250's hopefully on a bear....

Depending on how long your throat was cut you could load a little longer gaining some powder space = more velocity

Who made your Blaser barrel ?

I showed no signs of over pressure

Should be able to push it