AR15 Gas Key Screw Torque Specifications.
Posted: Wed Apr 18, 2012 5:31 pm
Here is a cut & paste from another forum:
QUOTE.
For years, veteran ArmaLite® assemblers have tightened carrier keys using a simple Allen wrench. This process has been successful.
As we added employees we decided to use calibrated torque wrenches to assure that we secure the key screws to the proper level. The government standard for carrier key torque is 35 to 40 inch pounds, and we secured torque wrenches set to that value. We then noticed an INCREASE in loose carrier keys. It turns out that we had tightened carrier key screws better without the wrench than with it.
The problem is that the government torque values shown in maintenance manuals are too low.
We have examined the engineering data related to the screw itself, and have increased torque to 55 inch pounds to improve carrier key tightness. We recommend that all AR owners make sure that their carrier key screws are secured to this level, especially if their rifles sometimes shows signs of weak or slow cycling.
If your AR “short strokes,” clean the underside of the carrier key and tighten both screws to 55 to 60 inch pounds. Tighten the front screw first. If your rifle isn’t short stroking, just make sure that the screws are tight and restake if needed.
UNQUOTE
Also found this.
Quote
Civilian 35-48 inch pounds
Mil Spec 50-58 inch pounds
UnQuote
QUOTE.
For years, veteran ArmaLite® assemblers have tightened carrier keys using a simple Allen wrench. This process has been successful.
As we added employees we decided to use calibrated torque wrenches to assure that we secure the key screws to the proper level. The government standard for carrier key torque is 35 to 40 inch pounds, and we secured torque wrenches set to that value. We then noticed an INCREASE in loose carrier keys. It turns out that we had tightened carrier key screws better without the wrench than with it.
The problem is that the government torque values shown in maintenance manuals are too low.
We have examined the engineering data related to the screw itself, and have increased torque to 55 inch pounds to improve carrier key tightness. We recommend that all AR owners make sure that their carrier key screws are secured to this level, especially if their rifles sometimes shows signs of weak or slow cycling.
If your AR “short strokes,” clean the underside of the carrier key and tighten both screws to 55 to 60 inch pounds. Tighten the front screw first. If your rifle isn’t short stroking, just make sure that the screws are tight and restake if needed.
UNQUOTE
Also found this.
Quote
Civilian 35-48 inch pounds
Mil Spec 50-58 inch pounds
UnQuote