Page 1 of 1

I have a question about 9mm Dies

PostPosted: Thu Jan 16, 2014 7:18 pm
by Texas Sheepdawg
Can you use a 9mm Parabelum die set to load the 380 Auto?

Re: I have a question about 9mm Dies

PostPosted: Fri Jan 17, 2014 12:26 am
by rugersr556
I'm not sure but i have a sizing die and bullet seating die for 380 acp you can have for 10$ +SH if you want.

Re: I have a question about 9mm Dies

PostPosted: Fri Jan 17, 2014 5:10 am
by Hoot
If you look up both those calibers on Wikipedia, you'll see that the 9mm case is a little bigger in diameter. I would be concerned that it would not size fired 380 brass down far enough to feed reliably (or at all) into a 380 chamber. I'd take Ron up on his offer if I were you.

Hoot

Re: I have a question about 9mm Dies

PostPosted: Fri Jan 17, 2014 8:45 pm
by Texas Sheepdawg
rugersr556 wrote:I'm not sure but i have a sizing die and bullet seating die for 380 acp you can have for 10$ +SH if you want.

Ruger, PM me

Re: I have a question about 9mm Dies

PostPosted: Mon Jan 20, 2014 3:26 pm
by rugersr556
Texas Sheepdawg wrote:
rugersr556 wrote:I'm not sure but i have a sizing die and bullet seating die for 380 acp you can have for 10$ +SH if you want.

Ruger, PM me


PM Sent.