So, there I was, at the local Gander Mountain where the clerk just told me that their clearance reloading equipment was an additional 50 percent off. So I picked up a set of brand new Hornaday 204 ruger dies for my prairie poodle blaster for $14.97.
Fast forward....
Couple days later, sitting at the reloading bench, prepped all my brass (once fired) cleaned and set up the dies, decap and size one case just fine, second case = problem. Expander button gets stock in case neck, zip spindle cuts loose and bam. Now I have an expander button and decap pin stuck in the case and not sure how to get it out, or why it happened.
I had the decap pin set at 3/16 below the die like they call for.
Suggestions please. I know it's not a 450 but if appreciate the help.
Thanks.
B.